3
Installation Specifications
Product Dimensions
36 1/4" *
(921 mm)
34 3/8"
(873 mm)
19 3/8"
(495 mm)
21 1/4" *
(540 mm)
4" (102 mm)
Chassis height
30 1/4" *
(768 mm)
28 3/8"
(721 mm)
19 3/8"
(495 mm)
21 1/4" *
(540 mm)
4" (102 mm)
Chassis height
Electrical Specifications
IMPORTANT
This appliance is provided with electrical connection
leads in a flexible metal conduit. These leads may be a
smaller gage than the standard household wiring of the
dedicated supply circuit, but they are suitable for connec-
tion to these circuits under the jurisdiction of the National
Electric Code, and/or the local inspection authority.
It is the owner’s responsibility to ensure that a licensed
•
electrician performs the installation of the electrical sup-
ply for this appliance. The electrical installation, includ-
ing minimum supply wire size, must comply with the
National Electric Code ANSI/NFPA 70 (latest revision)
and local codes and ordinances. A copy of the standard
may be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, Massachusetts 02269-9101
The correct voltage, frequency and amperage must be
•
supplied to the appliance from a dedicated, grounded,
circuit that is protected by a properly sized circuit
breaker or time-delay fuse. If a time-delay fuse is uti-
lized, fuse both sides of the line (L1 and L2).
The junction box and the remote circuit breaker panel
•
or fuse box, must be accessible when the cooktop is in
place.
Model
Dedicated
Circuit Required
Total Connected
Load**
ETT304-1
240 Vac, 60 Hz.
3 wire* 40 Amp.
6.9 kW
(29 Amp.)
ETT365-2
240 Vac, 60 Hz.
3 wire* 40 Amp.
9.1 kW
(38 Amp.)
MET304
240 Vac, 60 Hz.
3 wire* 40 Amp.
6.9 kW
(29 Amp.)
METB365-1
240 Vac, 60 Hz.
3 wire* 50 Amp.
9.6 kW
(40 Amp.)
* Two 120 Vac hot (L1 and L2) and one ground (all copper).
** For reference only. See the product data label (on the
bottom of the unit) for exact specifications. The minimum
wire size required by the manufacturer is 8 AWG. Local
codes may require that minimum wire gauge used exceed
this requirement for the power requirements listed on the
product data label.
Models ETT304-1, MET304
Models ETT365-2, METB365-1
All tolerances: ±1/16 (±1.6 mm), unless otherwise stated.
* For units with stainless steel trim,
other units may be up to 1/8” less
