6
WARNING
•
If the electrical service provided does not meet the
power requirements for the hood/downdraft vent and
the blower combined, do not continue with the instal-
lation. Contact a licensed electrician to correct the
situation before continuing.
•
Failure to connect the wiring as specified may result
in an electric shock hazard and/or improper blower
operation.
•
To avoid the risk of fire or electric shock, turn off
power at the circuit breaker panel or fuse box before
connecting the blower to the power source.
•
The blower assembly is heavy. Do not attempt to lift
or move it without assistance.
Parts List
Verify Package Contents
•
2 1/2” (6.4 cm) wood mounting screws (8)
•
Blower assembly
Parts Required
•
3 conductor wiring/conduit with UL certified strain relief
on each end (length is determined by remote blower
location).
•
If the blower will be mounted to a surface other than
wood, fasteners designed for the material the unit will
be mounted to must be provided. The fasteners must
be capable of supporting the weight of the blower (see
Weight Table
on page 4) and meet local codes and
ordinances..
•
Consult the hood or downdraft vent installation instruc-
tions for additional part requirements.
Installation
1. Before installing the blower, unpack the unit and check
for physical damage to the motor and blower assembly.
To do so, reach in through the intake collar and spin
the fan blades slowly. They should spin freely and qui-
etly without vibration.
2. Remove the blower’s top cover by removing the screws
around the edge that hold it in place.
3. Apply sealant between the blower and the mounting
surface where the flange around the edge of the blower
will rest.
4. With assistance, pick up the blower assembly and cen-
ter it on the mounting surface inserting the intake collar
into the cutout.
5. While holding the blower in place, fasten it to the
mounting surface with eight (8) mounting screws. The
mounting holes are located inside the blower assembly
chassis near the sides.
6. Install the duct work according to the installation
instructions for the hood or downdraft vent. Support the
duct weight as necessary to ensure properly sealed
joints.
Fan
blades
Bottom of blower
Intake
collar
Figure 6
Figure 7
Sealant
Roof
Air
exhaust
Sealant
Blower
Round duct
Flange
Figure 8
45° Adjustable
elbow
Installation Instructions
Summary of Contents for REMP3
Page 11: ......
