Dacor Renaissance RNWO130, Installation Instructions Manual

9

Installation Instructions

Electrical Connection

 WARNING

• If the electrical service provided does not meet the

Electrical Specifications

 (see page 4), do not

proceed with the installation. Call a licensed electrician

to correctly install the required wiring.

• Failure to disconnect power prior to installation may

result in an electric shock or fire hazard.

• Do not turn on power to the appliance until the oven is

properly grounded according to these instructions.

• The installer must connect the ground terminal (or

lead) on the appliance to a grounded, metallic, perma-

nent wiring system or grounding conductor. Failure to

do so may result in an electric shock hazard.

• Do not use an extension cord with this appliance. Such

use may result in fire, electric shock or personal injury.

• Do not install a fuse in the neutral or ground circuit. A

fuse in the neutral or ground circuit may result in an

electric shock hazard.

• The appliance must be connected to the power supply

with copper wire only. The use of aluminum wire may 

result in unsatisfactory conditions.

 IMPORTANT

Provide slack in the conduit to allow the oven to slide for-

ward for servicing.

 NOTE

The electrical connection leads from the supplied appli-

ance conduit may be a smaller gage than the standard 

household wiring of the dedicated supply circuit. They 

are suitable for connection to household wiring under the 

jurisdiction of the National Electric Code, and/or the local 

inspection authority.

1. Before proceeding, turn off power to the circuit to which

the oven will be connected at the circuit breaker or fuse

box.

2. Position the oven directly in front of the cabinet cutout.
3. Feed the appliance conduit into the junction box and

attach it using a UL approved strain relief.

4. Depending upon local codes, utilize one of three meth-

ods to connect the appliance to power:

◊

Connect to a four wire electrical system

◊

Connect to a three wire electrical system, where

local codes permit

◊

Connect to a three wire electrical system with

external ground, according to local codes.

See pages 9 to 11 for detailed directions.

Connecting to a Four Wire Electrical 

System

1. Separate the wires coming out of the appliance conduit.
2. Connect the white wire from the appliance conduit to

the white (neutral) supply wire in the junction box.

3. Connect the black wire from the appliance conduit to

the black (L1) supply wire in the junction box.

4. Connect the red wire from the appliance conduit to the

red (L2) supply wire in the junction box.

5. Connect the green wire from the appliance conduit to

the green (ground) wire in the junction box.

continued...

Incoming power

RED
RED

WHITE
WHITE

GREEN
GREEN

BLACK
BLACK

Wire nut,

4 places

Junction box

Conduit to 

oven

Four Wire Connection