Dacor Renaissance RNWO130, Installation Instructions Manual

6

Installation Specifications

Installation Planning

 WARNING

Observe all governing codes and ordinances during plan-

ning and installation. Contact your local building depart-

ment for further information.

 IMPORTANT

• Locate the junction box so that the oven may be easily

disconnected in the event that it needs to be removed

from the wall completely for service.

• If the oven is not installed level it may deliver poor or

inconsistent baking results.

•

Carefully check the location where the oven is to be

installed. The oven should be placed for convenient

access. Make certain that electrical power, meeting the

specifications on page 4, can be provided in the

selected location.

•

Dacor recommends installing the junction box in the

one of the locations shown on the facing page.

Minimum interior cabinet depth: 24” (61.0 cm)

•

Install the junction box in a location that allows the

oven to be removed from the cutout for service without

being disconnected.

•

Plan the installation so that all minimum clearances

are met or exceeded. Dimensions shown provide mini-

mum clearances, unless otherwise noted. Be certain

that proper clearance is provided for the oven door

when it is in the open position according the 

Product

Dimensions

.

•

Cabinet cutout dimensions must be used as indicated.

The specified minimum cabinet depth and width must

be provided. The cabinet depth and width must com-

pletely enclose the recessed portion of the oven.

•

All contact surfaces between the appliance and the

cabinet must be solid and level.

•

Provide a platform within the cabinet to support the

oven. It must be installed level and straight. The top

edge of the platform must be flush with the cutout at

the front of the cabinet. There are no provisions to level

the oven after it has been installed. 3/4” (1.9 cm) thick

plywood is recommended.

Model 

Number

(N) Minimum

Cabinet Width

(P) Minimum

Cutout Width

(R) Minimum

Cutout Height

R

NW

O[V]130

30” (76.2 cm)

28 1/2” (72.4 cm)

26 7/8” (68.3 cm)

R

NW

O[V]230

30” (76.2 cm)

28 1/2” (72.4 cm)

49 1/8” (124.8 cm)

Cabinet Dimensions

Cabinet tolerances: +1/16 (1.6 mm), -0, unless otherwise stated.