Dacor RNCT304, Use And Care Manual

9

Parts and Accessories

Description

Part Number

Dacor Cooktop Cleaning Creme

A300

Razor blade scraper (Ceran scraper)

82499

To order parts and accessories, contact your Dacor dealer or visit www.everythingdacor.com.

Problem

Possible Cause

Remedy

Food does not heat.

No power. 

See nothing works, above.

Non-magnetic utensil used.

Induction cooktops will not work 

unless utensil is magnetic. Try 

another type of utensil.

No pot or pan placed on cooking zone.

Use proper cookware. See page 

5.

Cookware not magnetic.
Cookware curved or warped on 

bottom.
Cookware not centered on cooking 

zone.

Center cookware on cooking 

zone as shown on page 5.

Cookware too small for cooking zone.

Move pot or pan to smaller 

cooking zone.

Supply voltage too low.

Have a licensed electrician check 

supply voltage.

Error code appears on display

An element may have overheated.

Error code E2 indicates that an 

element has over-heated. Turn 

off the control and allow the 

element to cool. Make sure that 

all cooling vents on the chassis 

are not blocked and make sure 

there is nothing covering the 

top of the cooktop, other than 

proper utensils. Element should 

reset after cooling and begin to 

work again. If element is still not 

functional, call for service.

Fluids spilled or items lying on or near 

the controls may cause an error code 

to be displayed and the cooktop may 

turn off.

Clean up any spills and remove 

any items near the controls.

Cooktop needs to be reset.

Turn off power to the cooktop, 

wait 10 seconds then turn power 

back on to see it the error code 

clears. If the error code returns, 

call for service.

Before You Call for Service