7
Installation Instructions
3. Secure the cooktop to the countertop using the two
(2) hold-down brackets provided. Slide the brackets
into the slots located on the left and right sides of the
chassis, then tighten the screws to the underside of the
countertop. Do not overtighten.
Electrical Connection
WARNING
•
To prevent an electric shock or fire hazard, turn off
power to the circuit at the circuit breaker panel or fuse
box prior to connecting the cooktop wiring.
•
Failure to connect the cooktop electrical wiring as
specified may result in an electric shock hazard, a fire
hazard and damage to the appliance.
•
Connect the ground (green) wire from the appliance
to a grounded, metallic, permanent wiring system or
grounding conductor. DO NOT ground the appliance to
a neutral (white) house supply wire. A separate ground
wire must be utilized.
•
This appliance must be properly grounded according
to these instructions any time power is applied.
•
If aluminum house supply wiring is utilized, splice the
appliance copper wires to the aluminum house wiring
using special connectors designed and agency-certi-
fied for joining copper and aluminum. Follow the con-
nector manufacturer’s recommended procedure care-
fully. Improper connection may result in a fire hazard.
IMPORTANT
Provide slack in the conduit to allow the cooktop to slide
out for service.
1. Before proceeding, turn off power to the circuit to which
the cooktop will be connected at the circuit breaker
panel or fuse box.
2. Feed the appliance conduit into the junction box and
attach it using a UL certified strain relief.
3. Depending upon local codes, utilize one of the two
methods shown on the following page to connect the
appliance to the junction box.
Verify the Package Contents
Verify that all the items below have been provided. If any
item is missing or damaged, please contact your dealer
immediately. Do not install a damaged or incomplete appli-
ance. Make sure that you have everything necessary to
ensure proper installation before proceeding.
•
Foam tape
•
Hold down brackets (2)
•
Glass scraper (PN 82499)
•
Dacor Cooktop Cleaning Creme (PN A300)
•
Product literature
Chassis Installation
WARNING
If the electrical service provided does not meet the speci-
fications on page 3, do not proceed with installation.
Call a licensed electrician to install the required wiring.
IMPORTANT
Do not use a hardening compound, glue or caulk to seal
the cooktop into place. The cooktop must be readily
removable if service is required. Removal of any sealant
to service the unit will be performed at the customer’s
expense.
1. Peel the protective backing off of the foam tape provid-
ed. Attach it to the underside of the cooktop mounting
surface, as close to the edge of the glass as possible.
2. Lower the cooktop into the cutout and center it. Make
sure the meets all minimum clearances stated on page
5.
Foam tape
Countertop
Cooktop
Foam tape
seal
Hold Down Bracket Installation - Side View
Hold down bracket and screws