19
Installation Instructions
Four (4) corners are bent backward 90 degrees.
Using the Dual to Single
Transition Kit# AHT10
On dual exhaust models, the two 8-inch duct exhausts can
be transitioned into one 10-inch duct.
Assemble the Dacor transition kit # AHT10
before hanging
the hood.
This transition kit fits over the top or rear ventila-
tion exits.
Preparing the AHT10
1. Create a lip around the transition kit by
bending the
bottom edges backward
at right angles to create a 3/4”
flange around the base.
IMPORTANT:
Rear vent, 12-inch tall
hood configurations,
keep one of the long edges straight
.
12-inch tall hoods are models: 3012, 3612, 4812
Bending the Flange for:
•
Top Vent Configuration:
None. Rear Only
•
Rear Vent Configuration
On models
3012, 3612, 4812
•
Notes:
12” hood height requirement
Keep one of the long edges straight!
One (1) edge remains straight and unbent.
12-inch
height
Bending the Flange for:
•
Top Vent Configuration:
3012, 3612, 4812
3018, 3618, 4818
•
Rear Vent Configuration
On Models:
3018, 3618, 4818
•
Notes:
18” hood height requirement
• If your hood model ends in “12” see above
18-inch
height
32”
(81.3 cm)
13 3/4”
(34.9 cm)
3/4”
(1.9 cm)
9”
(22.9 cm)
2” (5.1 cm)
Leave a long edge
straight and unbent.
This lip will act as a
bracket.
Summary of Contents for RNHP30 Renaissance
Page 31: ...29 Notes...
Page 32: ......
