User Manual AX32
Doc no. AX32-8002-A-4
Rev. date 140124
Page 24 of 31
Rear panel connections.
Figure 4, Rear panel layout
Rear panel layout
1.
Card slot 1 to card slot 8. 25 pole female D-sub connector with Tascam pin-out. Up to 6 pcs. 8-
channel analogue input or output cards can be installed. Slots 2 and 6 are currently not used.
2.
Mini module slot for dual optical MADI I/O via SFP.
3.
Power switch.
4.
Mains inlet. The same mains inlet is used even when a redundant power supply is installed.
5.
AES/EBU I/O channels 1-4. 25 pole female D-sub connector with Tascam pin-out.
6.
AES/EBU I/O channels 5-8. 25 pole female D-sub connector with Tascam pin-out.
7.
MADI I/O BNC connectors.
8.
DigiLink™ interface port for Pro Tools™ HDX, Primary port.
9.
DigiLink™ interface port for Pro Tools™ HDX, Primary port or Expansion port (configurable).
10.
Word Clock or Video Black Burst synchronization input (configurable), BNC connector.
11.
Word Clock synchronization output BNC connector.
12.
AES11/AES3 synchronization input, female XLR connector.
13.
Ethernet control and IP audio Primary port (net 1) RJ45 connector. Control port in redundant IP
audio mode.
14.
Ethernet control and IP audio Secondary port (net 2) RJ45 connector
15.
Reconfigure button, and status LED
Digital I/O Connections
Dual MADI SFP optical I/O mini-module
The Dual SFP optical module, can be installed with one or two
“Small form-factor pluggable” (SFP) transceiver modules.
The SFP modules are standard types which support various types of
optical interfaces with LED or Laser diodes, various wavelengths and
fibertypes. Each SFP module has a receiver and a transmitter part,
