MENU SETTINGS:
These are the settings found in the Main Menu.
1. Test Motion
2. Closed Position
3. Max Torque
4. Input Config
5. Closing Trip Level
6. Opening Trip Level
7. Home Trip Level
8. Object Detection Level
9. Open Speed
10. Closing Speed
11. Set < > Directions
12. Accel/Decel Config
13. Offset Open Position
14. Offset Enable
15. Auto Close Enable
16. Auto Close Delay
17. Volume(Audio/Beep)
18. Device ID
19. Ping Dist Set
20. Deadband
21. Temperature Comp*
22. Reset All Settings
* Factory settings. Do not change.
4
BYPASS MODE:
If required, at power ON the user can immediately PRESS and HOLD down the
Setup Mode Button until the Main Menu appears, this will bypass the
diagnositcs and HOMING process. This BYPASS approach to the Setup Mode is
for special cases where the user may need to make some adjustments prior to
the system running the diagnostics and HOMING routine.
DO NOT ATTEMPT TO
OPERATE THE DOOR FROM THIS MODE USING TEST MOTION, THE DOOR MUST BE
HOMED PRIOR TO MOVING THE DOOR. If using the Bypass Mode, once you exit
the Setup Mode by turning off the RED LED, the system will automatically begin
the diagnostics and homing routine.
