[Cleaning Battery Terminals]
①
Turn the seat lock switch to the right
using the main switch key.
②
Loosen the washer screw and remove
the battery cover.
③
Loosen the tapping screw and remove
the battery holder.
④
If the battery terminal is polluted, or in
rust, separate battery and clean it.
⑤
Battery terminal in rust with white
powder should be cleaned with warm
water.
⑥
In case of serious rust of battery ter-
minal, disassemble the battery cord
and grind it with wirebrush or
sandpaper.
[Replenishing Battery Water]
This vehicle doesn’t need either reple-
nishing or checking battery water because
of the equipment of enclosed MF battery.
In case battery needs a checking, it should
be cared of by service center.
42
Battery Inspection
Caution
●
Be careful not to disassemble in-
jection part of enclosed battery.
●
When not using vehicle during a
long time, take off the battery from
the vehicle to keep from self-
discharge and electric discharge.
Put the battery in a well ventilated
place after charging fully. In case it
isn’t available to take battery off
from the vehicle, disconnect “-”
terminal.
BATTERY
Caution
●
Turn the ignition switch OFF
before disconnecting the terminal
from the battery.
●
When cleaning battery, do not
disassemble the battery cap to
prevent foreign materials from
falling inside battery.
●
Remove the negative pole
side
cord first and the positive pole
side cord next.
●
Make sure, at this time, that
side cord is connected first,
followed by
side cord.
