8-8
A.C GENERATOR / STARTER CLUTCH
STARTER ONEWAY CLUTCH SET
LOCK NUT
SPECIAL SOCKET
RH. CRANKCASE
COVER
STARTER CLUTCH INSTALLATION
●
Install the starter oneway clutch set, starter driven gear
and needle bearing to the starter clutch assembly.
●
Install the starter clutch to the RH. crankshaft.
NOTE
·
When installing the starter clutch, match it with the
groove accurately
●
Install the thrust washer.
●
Temporarily install the starter clutch lock nut.
●
Hold the drive face with the drive face holder.
●
Tighten the starter clutch lock nut with a special socket.
NOTE
·
Tighten the lock nut with specified torque.
TORQUE VALUE : 9.5 kgf
·
m
TOOLS : SPECIAL SOCKET (12.7x28x120)
DRIVE FACE HOLDER
●
Install the following parts.
-
RH. crankcase cover (
⇨
7-2
)
-
A.C Generator (
⇨
8-2
)
-
Cooling fan (
⇨
8-2
)
-
RH. shroud (
⇨
8-2
)
-
Rear swing arm (
⇨
13-8
)
-
Rear caliper (
⇨
14-6
)
-
EX. muffler (
⇨
4-12
)
-
RH. floor side cover (
⇨
4-7
)
-
LH. crankcase cover (
⇨
7-2
)
●
Tighten the rear cushion upper bolt.
Summary of Contents for HISTORY 125 - SERVICE
