Daewoo International DBU-38, Instruction Manual

10 

SKIP TO THE PREVIOUS/NEXT FOLDER (MP3/USB) 

1. During playback, press and hold the FOLDER/10+ button until the folder number flashes 

on the screen. 

2. Press the SKIP/SEARCH DOWN button or SKIP/SEARCH UP button to select the folder 

you want. 

3. Once the selected folder number shows on the screen, press the FOLDER/10+ button to 

confirm. 

REPEAT PLAYBACK (CD/MP3/USB)

During playback, press the PROG/MODE/MEM button to repeat play a single track; press 
the button twice to repeat play all tracks; press the button three times to enter the 
introduction play mode; press the button four times to enter the random play mode; press 
the button five times to exit.

 
PROGRAMMED PLAY (CD/MP3 DISC/USB) 

1. At stop mode, press the PROG/MODE/MEM button once, the program’s icon shows with 

a program sequence indication "P01" first, then a track number flickers on the LCD with 
the program’s icon. 

2. Select the first track to be programmed using the SKIP/SEARCH UP button or the 

SKIP/SEARCH DOWN button, and then press the PROG/MODE/MEM button again to 
store and advance to the next programming step (If there are several folders on the MP3 
disc or USB, it is necessary to program folders first and then the tracks. The method of 
the folders programming is the same as the tracks programming.).   

3. Repeat the above steps to program more tracks. A maximum of 20 tracks for CD and 99 

tracks for MP3 disc/USB can be programmed in memory in a preferred order. If the 
memory is full, the screen will show “FUL” for indicating. 

4. Press the PLAY/PAUSE/CH+ button to begin programmed play in the preferred order 

after you are done with programming. The player stops automatically after all 
programmed tracks are played. 

5. You may press the STOP/CH- button to terminate programmed playback. In program 

stop mode, press the PLAY/PAUSE/CH+ button to begin the programmed playback with 
the programming order identical with the previous one done; press the STOP/CH- button 
again to clear the programming. 

AUX IN 

1. Connect the Aux in jack on the unit to an audio source, for example, MP3 player with an 

audio cable. 

2. Power on the unit following the corresponding instructions. 
3. Press the SOURCE button repeatedly to switch to AUX mode. 
4. Use the native controls on the connected audio device to begin playing music through the 

connected unit. 

STEREO PHONE JACK 

A stereo earphone jack has been provided on the back side of the player so that you can 
listen without disturbing others. To use this jack, plug in the headphones/earphones (NOT 
INCLUDED) and adjust the volume level to a preferred level. 

NOTE:

 When external headphones/earphones are connected, the speakers will be muted. 

CAUTION:

 Listening at high power for a long moment could damage users' ears.