Power Train
Disassembly & Assembly
3.
Use a hammer and punch to remove roll pin (6)
from the carrier. Remove pin (8), side gears (7)
and the thrust washers.
4.
Remove axle gears (9) and the thrust washers. If
bearing cones (5) need to be replaced, use tool
(B) and a press to remove them from the carrier.
5.
Remove cover (10) from the housing assembly.
Remove the cap from over pinion nut (11). Bend
the lockwasher away from nut (11). Remove nut
(11) with tool (C). Remove the lockwasher and
washer.
6.
Remove outer bearing cone (17), shims (23) and
ring (22) from the pinion shaft. Pull pinion shaft
(12) out of gear (15) and the housing assembly.
Remove ring (21) from the pinion shaft. Remove
the gear from the side of the housing assembly
that cover (10) was removed from.
7.
If necessary, remove inner bearing cone (13) from
the pinion shaft with a press.
8.
If necessary, remove bearing cups (18) and (20)
and shim (19) from the housing assembly.
9.
Remove the snap ring (24) from the gear shaft
(26).
10.
If necessary, remove the bearings (25) from the
gear shaft (26) with a bearing puller.
24
25
26
40
5
6
8
7
9
10
11
IDCD356S
12
13
21
15 22 17
11
20
23
19
18
