Built-h BIOS Setup Program
PM Control by APM Sets the power management (PM) control by the
APM. The available options are :
-Yes (default)
Video Off Method -Sets the video power green method. The available
options are :
-V/H
-Blank Screen
Video Off After Turns off screen after selected standby or suspend
mode. The available options are :
suspend
-Doze
Modem Use IRQ In order to support resume on ring and to be
compliant with APM 1.2, this option is required to be set same IRQ as
the modem add-in-card used. The available options are :
-3
Doze Mode Sets the time interval after system inactivity when the
system enters Doze mode. The available options are :
Hour/Disable
Standby Mode. Sets the time interval after system inactivity when the
system enters STANDBY mode. The available options are :
1 Min (default)
Built-In
Setup Program
Suspend Mode -Sets the timer interval after system inactivity when the
system enters SUSPEND mode. The available options are :
1 Min (default)
Hour/Disable
HDD Power Down Sets the interval time to power down
The available options are :
1
Throttle Duty Cycle Selects the percentage of time the
signal is asserted which the throttle mode. The available options are :
12.5%
75.0%
ZZ Active in Suspend Determines whether to assert the
signal
while in suspend mode or not. The available options are :
Enabled
VGA Active Monitor-Determines whether to reload burst timer while
accesses to VGA
addresses or the A and B segment video
memory ranges or not. The available options are :
-Disabled
Soft-Off by
Sets power button override function.
needs to press power button for over 4 seconds to power off a system if
this option is set by “Delay 4 Sec.” The available options are :
-Delay 4
-Instant-Off
Off In Suspend
off CPU fan while in suspend mode.
The available options are :
-Disabled
