Built-h BIOS Setup Program
Built-In BIOS Setup Program
PNP OS Installed Tells if
OS is installed. The available
IDE
.
a
Interrupt pin which will be used by
:
-NO
I
the primary channel of a
IDE card. The available options are :
-A (default)
-B/C/D
Controlled By
user what kind
assignment to
Secondary IDE
Selects a
Interrupt pin which
be used
be used. The available options are :
by the secondary channel of a
card. The available options are :
Manual
(default)
-A/C/D
, The default of “Resources Controlled By” is Auto. If users set
to “Manual”, the option for the setting
assigned to”
will be shown on the screen.
Reset Configuration Data To clear the
data which is stored in
flash ROM, please set “Enable”. This is a one short switch. After
clearing the ESCD, the BIOS will change the value back to “Disabled”.
The available option are :
-Enabled
IDE IRQ Map To Most of
IDE cards are
compliant,
Defines the IRQ Routing to make them work properly.
The available options are :
ISA
PCI-SLOT 2
PCI-SLOT 3
PCI-SLOT 4
If user sets this option to “ISA”, both the “Primary IDE
and “Secondary IDE
options below will not be shown
on the screen.
Used MEM base addr This option will be shown only when
Controlled By” option is set to “Manual”.
The available options are :
-N/A (default)
Used MEM Length If the option “Used MEM base addr” is set to
“N/A”, this option will not be shown on the screen.
The available options are :
Assign IRQ For VGA To assign
which will be used by Video
card. The available options are :
-Disabled
In the event of a loss in memory on the configuration SETUP, the
can restore the information on the BIOS by default values. Loading the
BIOS defaults provides safety booting of the system.
SETUP defaults are considered default values with which the system
will be enabled to perform better. This due to the enabling of
options
within the SETUP program. However, if problems are encountered
after loading the Optimum Setting, reboot the system and load the
BIOS defaults instead.
User’s
