Built-h BIOS Setup Program
Mode -Determines which type
module want to use.
The available options
:
-standard (default)
1.0
ASK
If users set this options to “Standard”, the
Duplex
Mode” option below will not be shown on the screen.
Duplex Mode Allows users to control the infrared communication
duplex mode. The available options are :
-Half (default)
Full
Parallel Port Sets the I/O address for the parallel port
The available options are :
378h IRQ7 (default)
-Disabled
278h
3BCh IRQ7
Parallel Port Mode-Sets the l/O address for the parallel port.
The available options are :
(default)
-Disabled
If users set this options to “Disabled”, the
Mode” option below will not be shown on the screen.
Parallel Mode Selects the working mode of parallel port,
The available options are :
SPP (default)
+ EPP
Built-In BIOS
Setup Program
If
set this options to “SPP”
the “ECP Mode
option below will not be shown on the screen.
ECP Mode Use DMA Selects the DMA channel of ECP Mode to
Transfer your data. The available options
:
3 (default)
-1
The SUPER VISOR PASSWORD utility allows you to set, change, and
disable the password which is stored in the BIOS. To change the password
setting. press <Enter> on the SUPERVISOR PASSWORD option of the
main
and then type the new password.
Configure the Security Option within the BIOS Features Setup
to the setting in this utility. SUPERVISOR PASSWORD access
right is higher then USER PASSWORD.
The password can be at most 8 characters long. The program will require
you to confirm the new password before it exits and enables the utility.
To disable the SUPERVISOR PASSWORD, press the
when the
program asks you to enter the new password.
USER PASSWORD only can be used when the system is booting. Users
only can enter SETUP screen to change the USER PASSWORD.
