![background image](http://html1.mh-extra.com/html/daewoo/d35s-2/d35s-2_operation-and-maintenance-manual_3222899156.webp)
Maintenance Section
-154-
Carriage Chain Adjustment
Make sure that carriage height is correct. If correct,
adjust the chain for equal tension. If not, adjust the chain
for correct carriage height by adjusting anchor
nuts(1),(2).
NOTE:
See the previous section, “Carriage Roller
Extrusion” in “When Required” for proper height
of carriage.
1.
Fully lower the carriage and tilt mast forward or lift
the carriage and put blocks under the carriage to
release the tension from the lift chains.
2.
Loosen nut(1) and adjust nut(2) to get proper
distance from bottom of inner upright to the bottom
of carriage bearing.
Typical example for carriage chain of STD mast
Typical example for carriage chain of FF,FFT mast
3.
Make adjustment anchor nut(1),(2) for equal chain
tension.
4.
Set the mast vertical and raise the carriage and
check equal chain tension. If not equal, repeat the
same procedure as step 1 through step 3.
5.
Put LOCTITE No. 242 Tread lock on the threads of
the anchor nuts(1),(2) after the adjustment is
completed.
Mast Chain Adjustment - FF,FFT Mast
Typical example for FF mast
Typical example for FFT mast
Make sure that mast height is correct. If correct, adjust
chain for equal tension. If not, adjust mast chain for
correct mast height by adjusting anchor nuts (3), (4).
NOTE:
See the previous section, “Carriage Roller
Extrusion” in “When Required” for proper inner
mast height.
1.
Lift the inner mast and put blocks under the inner
mast to release the tension from the lift chains.
2.
Loosen nut(3) and adjust nut(4) to make inner mast
rail flush with outer mast rail bottom.
3.
Make adjustment anchor nuts(3),(4) for equal chain
tension.
4.
Raise the inner mast and check equal chain tension.
If not equal, repeat the same procedure as step 1
through step 3.
5.
Put LOCTITE No. 242 tread lock on the threads of
the anchor nuts(3),(4) after the adjustment is
completed.
Summary of Contents for D35S-2
