- 151 -
CODE
Fault Point
Regular Specification
Repair Hint
C16
ENGINE SPEED
Error in engine RPM
1.Check the signal between
SENSOR ERROR
sensor
pin No.10 pin and pin No.23 of ECU
2.Check the resistance of pick-up sensor :
2.5`0.5K
3.Check if cable is short or open
4.Check the contracts of connector
C14
PRESTROKE
Error in prestroke
CHECKING CONDITION-Key on
OFFSET LEARNING
offset learning
1.Check the resistance of prestroke actuator
ERROR
sensor as follow
pin No.6 pin and pin No.7 of ECU
pin No.6 pin and pin No. 19 of ECU
pin No.7 pin and pin No. 29 of ECU
2.Check the ECU
3.Check if cable is short or open
4.Check the contacts of connector
C13
PRESTROKE
Error in prestroke
CHECKING CONDITION-Key on
SENSOR ERROR
sensor
REGULAR VALUE-f=18`2kHz
1.Check the resistance of prestroke
actuator sensor as follow
pin No.6 pin and pin No.7 of ECU
pin No.6 pin and pin No.19 of ECU
pin No.7 pin and pin No.29 of ECU
2.Check the prestroke sensor
3.Check if cable is short or open
4.Check the contacts of connector
C12
PRESTROKE
Error in prestroke
CHECKING CONDITION-Key on
CONTROL SERVO
actuator servo control
1.Check the voltage of prestroke actuator
ERROR
sensor as follow
pin No.6 pin and pin No.7 of ECU
pin No.6 pin and pin No.19 of ECU
pin No.7 pin and pin No.29 of ECU
2.Check the prestroke actuator status
3.Check if cable is short or open
4.Check the contacts of connector
5