3.3.7. Rear oil seal
1) Apply lubricating oil to the outside of the
oil seal and flywheel inside diameter and
fit them over the crank shaft, then
assemble the oil seal using an oil seal fit-
ting jig.
- 64 -
EQM3061I
3.3.8. Flywheel
1) Install a guide bar into a bolt hole on the
crank shaft, and lift the flywheel to align
the dowel pin with the pin hole on the fly-
wheel for temporary assembly operation.
2) Install bolts in the remaining holes with
no guide bar installed, take out the guide
bar, then install a bolt in the hole where
the guide bar had been inserted.
3) Tighten the fixing bolts using a torque
wrench in a diagonal sequence to speci-
fied torque(18kg•m).
EQM3062I
2
6
4
8
1
5
7
3
EQM3063I
3.3.9. Timing gear case
1) Mount gasket using dowel pin.
2) Install the timing gear case by aligning
the dowel pin with the dowel pin hole on
the timing gear case.
EQM3064I
<Tightening sequence for flywheel fixing bolts>