23
The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based cleaner products.
Use rubber gloves to protect hands. Carefully read the material safety
instructions on the container of the ice machine cleaner.
DISCARD the first batch of ice troduced after cleaning.
save them in an ice chest or cooler.
Remove the screws in the front cover, push forward to remove the front cover.
Notice: Don’ t overexert,
or the leads connected with the power switch can be
torn down.
Put the front cover against the right side cover.
3.
Locate the control box.
4.
Turn on the power to the
ice maker. Pour 230g of
Nickel-Safe Ice Maker
Cleaning Solution into
the water bin. Add 230g
of tap water. After about
5 minutes, press down
the "clean" button on the
Control Box. (See figure
below and following
section.) The machine will run the
Automatic Clean Mode.
5.
Allow 30 minutes for proper cleaning. After
cleaning, shut off the power switch, and
unscrew the nut of the water-draining hole.
Drain off the waste water to some container,
and then screw the nut on tightly when the
waste water is fully drained off.
6.
Repeat steps 4 and 5 (without Ice Maker
Cleaning Solution) to rinse the ice making
system 3 times.
Note: The use of the Ice Maker Cleaner Solution in the water bin during
the rinse is not needed.
7.
Prepare a sanitizing solution made of 28g of household bleach and 7.5L of
hot water (35
℃
to 46
℃
). Remove the flake covers and slideway from the
water bin and wipe the entire bin inside and out, covering the entire
surface of the walls.
Water bin
