Parts of the remote
controller
23
20. STILL : Press this button to freeze the picture.
21. RECALL : Display the present modes (ATV/DTV,
Video1/2, Comp.1/2, PC/HDMI) and Signal
information for 4 seconds.
Note. : In Analog TV mode, you can see information
about the Programme number, Sound, and Clock. In
DTV(DVB-T)mode, you can see information about a
channel number, name, broadcasting time and more.
22. ASPECT : Select screen aspect ratio : Wide[16:9] =>
Zoom1 => Zoom2 => Normal[4:3] => Wide[16:9]
Note. : When current mode is multimedia (PC, HDMI,
Component), the aspect only work as the 16:9 mode.
23. PICTURE : Picture modes change as follows :
Normal => Soft => Movie => User => Sharp => Normal
24. SLEEP : Sleep Timer setting.
SLEEP TIMER : OFF => 30min => 60min => 90min => 120min => OFF
Note. : If an active signal is not present for about 30
minutes, the set will automatically turn to ST-BY mode.
25. S.EFFECT : Using this button, Select the desired sound mode.
Off => BBE => M.Voice => 3D Panorama => Off
26. Red button : Delete the channel in EDIT and teletext.
27. Green button : Move the channel in EDIT and teletext.
28. Yellow button : Skip the channel in EDIT and teletext.
29. Blue button : Teletext.
30. Teletext : see page 49.
Inserting Batteries into the Remote Control Unit
To load the batteries, turn the remote control handset over
and open the battery compartment. Insert the batteries (Two
1.5v, type AAA).
Make sure that the polarity matches with the (+) and (-)
marks inside of the battery compartment.
Note
: To avoid damage from possible battery leakage,
remove the batteries if you do not plan to use the
remote control handset for an extended period of time.
