Daewoo DSC-3270E, Instruction Manual

4

INSTALLATION

If the set is moved or placed in a different direction, the MAIN POWER button

must be switched off for at least 15 minutes in order to take out a colour strain
on the screen.

Press down the battery compartment grip and slide the cover.
Insert the batteries supplied (two 1.5V, type AAA).
Make sure that the polarity matches with the (+) and (-) marks inside of the bat-
tery compartment.  

For better picture and sound quality, an effective aerial installation is the most
important.
When using an outdoor aerial, it is usually connected to the set by means of 75
ohm coaxial cable.

Plug the mains cable into the power socket with 220V - 240V / 50Hz AC.

Additional Information for the set sold in Great Britain
The appliance is supplied with a moulded three pin mains plug fitted with a 5 Amp
fuse. Should the fuse require replacement, it must be replaced with a fuse rated
at 5 Amp and approved by ASTA or BSI to BS1362.
The plug contains a removable fuse cover that must be refitted when the fuse is
replaced. In the event of the fuse cover being lost or damaged, the plug must not
be used until a replacement cover has been obtained. Replacement fuse covers
can be purchased from your nearest electrical dealer and must be the same
colour as the original.
If the moulded mains plug is unsuitable for the socket outlet in your home or is
removed for any other reason, then the fuse should be removed and the cut off
plug disposed of safely to prevent the hazard of electric shock.
There is a danger of electric shock if the cut off plug is inserted into any socket
outlet.
If a replacement plug  is to be fitted, please observe the wiring code shown
below. The wires in the mains lead are coloured in accordance with the following
code:

Blue - Neutral           Brown - Live

As the colours of the wires in the mains lead of this appliance may not corre-
spond with the coloured markings identifying the terminals in your plug, proceed
as follows:
The wire which is coloured blue must be connected to the terminal which is
marked with    the letter N or coloured black.   The wire which is coloured brown
must be connected 
to the terminal which is marked with the letter L or coloured red.

Do not make any connection to the terminal in the plug which is marked by the

letter E or by the safety earth symbol

or  coloured green or green and yel-

low.

INSERTING BATTERIES INTO THE REMOTE CONTROL UNIT

AERIAL CONNECTION

MAINS CONNECTION