DTC-370
14
SETTING A NUMBER AS VIP
In on-hook state, review the desired incoming or outgoing number,
Press
VIP/P
key to set the number as VIP number. There will be a
icon displayed on LCD.
Press
VIP/P
key again, the VIP number will become to ordinary number and the
icon will disappear.
The number set as VIP number can not be deleted, but when press
DEL
key for 3 seconds, all numbers
will be deleted including the VIP numbers.
Notes:
When the number stored full, the unit will auto-cover the earliest ordinary one except of VIP number.
But if the numbers are all set as VIP number and the memory is full, the unit will auto the earliest VIP
number. It will ring a special ringing tone when a VIP call comes.
SETTING MENU
SETTING DATE AND TIME
In on-hook state, press
SET/ST
key, LCD displays
SET 1 DATE
.
Press
SET/ST
key, the last two digits of year flash.
Press
▲
or
▼
key to edit the year, press
SET/ST
key to confirm, by using the same method to set the
month, date, hour and minute. Press
DEL
key to quit.
Note: Month: 1-12 Date: 1-31 Hour: 00-23 Minute: 00-59
SETTING LOCAL AREA CODE
You can set a local area code useful in some countries to avoid dialing the area in every call, if you do not wish
to set a code, you can leave it as
CODE - - - - -.
In on-hook state, press
SET/ST
key and then press
▲
key, LCD will display
SET 2 CODE
Press
SET/ST
key again, LCD displays
CODE - - - - -
Press
▲
or
▼
key to set the first digit of local area code.
Press
SET/ST
key to confirm and enter the second digit setting, follow same steps to set the last 4 digits.
Press
DEL
key to quit.
Note:
If the local area code only 4 digits, the last digit can be left as “-”. After set the local area code, unit will
auto-filter the area code if the incoming call number with the first several digits as same as the local area code.
SETTING PABX CODE
You can set a PABX code when the phone is connected to a telephone switchboard, this will avoid you to dial
the code each time you want to dial an outgoing number, if not, leave this code empty
PCODE --
,
In on-hook state, press
SET/ST
key and then press
▲
key 2 times, LCD will display
SET 3 PCODE
.
Press
SET/ST
key to confirm, LCD displays
PCODE --
, the first “-“flash and indicate to set the first digit of
PABX code.
Press
▲
or
▼
key to set the PABX code. Press
SET/ST
key to confirm and enter the second digit setting.
Following same steps to set the second digit.
Notes:
If only one digit of PABX code, left the second digit as“-“.
If set PABX code, when dialing back incoming call or pre-dial a number, and if the number is 6 digits or
more than 6 digits, the telephone will auto-add PABX code ahead the incoming number or the pre-dialing
number which is not lead by PABX code and then pause 1 second.
