EN
34
Notes:
1) If the handset and base is fail to registration successfully, the handset will return to the
standby mode.
2) You can repeat the above steps to register another handset for the same base, and the
successfully registered handset will displays
HS2
or
HS3
on the LCD according to the
registration sequence.
3) Press
key to page the handset when diffi cult to look for.
ADVANCED FUNCTION
Handset and hands-free mode
Press
or key once to obtain a dial tone, dial your number, when you hear the called
party answers the phone, you can begin your conversation.
During the conversation, press
or key to transfer the conversation mode between
handset and hands-free.
Hands-free and handset volume control
During handset mode, press
or
key to adjust the handset volume. There are 5 levels for
selection.
During hands-free mode, press
or
key to adjust the speaker volume. There are 6 levels
for selection.
Mute the speakerphone
During a call, press
MUTE
key once to mute the mouthpiece and
MUTE
will show on LCD.
Press
MUTE
key again to get back to the call and the
MUTE
will disappear.
Caller ID – type I & II
* TYPE I
After you have applied the caller ID service, you can see the caller phone number during an
incoming ring.
* TYPE II
During the conversation, the phone number of the incoming call of the second caller can be
seen in the unit. This function can be worked when the user applied the Telecom service.
Flash
When dial a number and the line is busy, press
R/CLR
key and
RD/P
key to dial it out again.
Pause
Press
RD/P
key will insert a time delay of 3.6 seconds in a dialing sequence.
Pre-dialing
The unit has pre-dialing function, when you may enter and edit the number before dial it out.
