EN
36
Three-way conference call
1. When a call comes, Press
key or .
2. Then press
INT
key once, you will be prompted to select the number of the internal
handset with which you wish to connect, press the registered number of the handset you
want to call.
3. The destination handset will ring.
4. Press
key or key to accept call.
5. Press the
key of the initial handset, then you can talk all together.
6. Press to quit the three-way conference mode, then other parties can also continue to
communication.
TROUBLE SHOOTING
*
No signal bar is displayed on the screen
- The handset is out of range. Move it closer to the base station
*
No dialing tone
- Check your phone connections
- The handset is out of range. Move it closer to the base station
*
No docking tone
- The handset is not placed properly on the base station/ charger
- The charging contacts are dirty. Disconnect the power adaptor fi rst and clean the contact
with proper damp cloth.
*
The handset on the charger does not charge
- Make sure the batteries are inserted correctly.
- Make sure the handset is placed properly on the base station/ charger
- Batteries are defective. Purchase new ones for replace.
*
No display
- Make sure the batteries are charged
- Make sure there is power and the phone is connected
*
The handset no ring
- Make sure the handset ring tone is turned on.
*
Ring volume too low
- Check if the ringing volume is set improper, reset it.
