29
DAEWOO Video Cassette Recorder User’s Guide
28
DAEWOO Video Cassette Recorder User’s Guide
Other Imformation
,
c
ontinuación
Recording Problems
Will not record
• Check to make sure there is a tape in the VCR.
• Try ejecting and reinserting the cassette.
• Check to make sure the tape is not broken.
• Check to make sure the VCR is not in pause mode.Press PAUSE or PLAY to return to normal
playback.
• Check the Pro-Tect Plus ™ feature..
Timer recording not made or wrong program recorded
• Check to make sure the program was entered correctly (wrong channel or times).
• Check to make sure the cable box or satellite receiver was turned on when recording was to
begin.
• Power interruption.Reset the clock.
• Check to see if time and date are correct – including AM//PM.
• Check to make sure the program did not exceed the tape ’s length or the tape was not
rewound beforehand.
• Check to make sure the VCR was turned off at the time recording was to start.
• Check to make sure there was a tape in the VCR and the cassette ’s safety tab was intact.
• VCR ejects cassette when the end of the tape is reached during a timer recording.
Will not record
• Check to make sure the safety tab is intact.
• Check to make sure the VCR is not in the line mode.Press INPUT on the remote.
Playback Problems
Snowy or no picture during playback
• Press TV •VCR to turn VCR indicator on.
• Check TV channel selected (3 or 4)to make sure it matches the channel selected with
CH.3/4 switch on the back of the VCR.
• Check to make sure the TV ’s fine tuning is correct for the channel selected.
• Check video cable connections between VCR and TV monitor.
• Check to make sure the TV monitor is set to Video Input (see How to Find Your TV ’s Video
Input Channel in this section of the manual for detailed information).
• Try another tape.
• Some snow/streaks are normal during search,stop action,frame advance,and slow-motion
playback.
Streaks in picture during normal playback
• Press one of the TRACKING buttons to move streaks up or down for the best picture.
• Check to make sure the tape is of good quality and not worn out.
Time counter not working or time counter not working in search modes
• The time counter does not advance during unrecorded portions of tape.When an
unrecorded segment of tape is encountered,the time counter will hold its count until
recorded material is detected again.
• A minus (–)will appear in front of the time if you rewind the tape farther back than a
counter reading of 0:00:00.
• The time counter disappears during search;this is normal.
Will not play
• Check to make sure there is a tape in the VCR.
• Try ejecting and reinserting the cassette.
• Check to make sure the tape is not broken.
• Check to make sure the VCR is not in pause mode.Press PAUSE or PLAY to return to normal
playback.
• Check the Pro-Tect Plus ™ feature..
Will not Auto Channel Search active channels correctly
• Check to make sure the antenna connections are secure and correct.
• Check to make sure the Signal Type:CABLE/ANTENNA feature is set correctly.
• If Detect Automatically was selected for the Signal Type in the AUTO CHANNEL SEARCH
menu,try using either CABLE TV or ANTENNA instead.
• May not be necessary if using a cable box for all channels.Contact your local cable company
for more information.
Tape plays back in slow motion
• Press PLAY to return to normal playback.
Cassette with safety tab removed does not start to play automatically
• Check to make sure the AUTO PLAY ON/OFF feature is set to ON .
Time counter disappears during searching
• This is normal.
Other Imformation
,
c
ontinuación
