26
* DRY
Put the laundry into the Drum and close the Door.
Press the Power button.
• The LED shows only '- --' signal.
Select the 'DRY CONDITION' you want by pressing 'DRY' button.
As this button is pressed, the dry condition is selected by 'Cupboard'
→
'Very'
→
'Time(1:00, 2:00, 3:00)'
→
OFF
→
'Low Temp'
→
'Iron'
→
'Cupboard'
Press the 'Start/Pause' button.
• The washer will be operated with locking Door.
1
2
3
4
Note
• Do not use the detergent and softener.
• Check if Cold water tap should be opened.
• After finishing this program,
is showed on PCB board alternately and the smoothing creases program is
conducted during 30 minute and then power is OFF.
• At 'Wool', and 'Blanket' program, DRY can not be selected.
• Be careful the high temperature of laundry when put out clothes.
• A little shrikage and deformation will be possibly happened after drying, so check clothes whether dry or not previously
• If the dry performance is poor, change the dry condition.
• If youn want to dry with wash, after selecting program, press the 'DRY' button then press 'Start/Pause' button.
* ONLY SPIN
Put the laundry into the Drum and close the Door.
Press the Power button.
• The LED shows only '- --' signal.
Select the 'SPIN CONDITION' you want by pressing 'SPIN' button.
• The 'NORMAL' program is selected automatically.
• The water temperature is selected to 'Cold' automatically.
Press the 'Start/Pause' button.
• The washer will be operated with locking Door.
1
2
3
4
* ONLY RINSE
Put the laundry into the Drum and put the detergent and softerner into the detergent case.
Then close the Door.
Press the Power button.
• The LED shows only '- --' signal.
Select the 'RINSE' time(S) you want by pressing 'RINSE' button.
• The 'NORMAL' program is selected automatically.
Press the 'Start/Pause' button.
• The washer will be operated with locking Door and supplying water.
1
2
3
4
