6
ELECTRICAL REQUIREMENTS
• Electrical earth is required on this washer
• If it does not fit the outlet, have a proper outlet
installed by a qualified electrician.
• Don’t earth to a gas pipe.
• Don’t change the power supply cord plug.
• Check with a qualified electrician if you are not
sure the washer is properly earthed.
WARNING
Recommended earthing method
Electrical shock hazard : Failure to follow these instructions could result in death or serious injury.
For your personal safety, this washer must be earthed.
This washer is equipped with a power supply cord ‘A’ having a earthing plug ‘B’.
To minimize possible shock hazard, the cord must be plugged into a mating earthing-
type wall receptacle ‘C’. If a mating wall receptacle is not available, it is the personal
responsibility and obligation of the customer to have the proper earthed wall
receptacle installed by a qualified electrician.
C
B
A
Drain system
• Never forget to install drain hose before operating your washer.
• Open the packing box, and there is a drain hose inside the drum.
• Connect the drain hose to the drain outlet at the back side of the washer.
• Proper securing of the drain hose will protect the floor from damage due to water leakage.
• When the drain hose is too long, do not force it back into the washer. This will cause abnormal noise.
• For Pump Model
Top of laundry tub must be at least 60cm high and no higher than 100cm For Pump Model of washer.
When installing the drain hose to tub(sink), secure it tightly with a string.
• For Non-Pump Model
If you need to extend drain hose,
contact the sales agent, or service center.
Level adjustment
1
If the washer is installed on an unsuitable floor,
it could make considerable noise, vibrate and
cause a malfunction.
contacting outlet
Connect the - type end
of drain hose to the end
of contacting outlet securely.
less than 1m
less than
10cm
Height of
Length of
drain hose
drain hose
if the height of drain hose
less than 10cm
less than 1m
is elevated in the middle
If not the height of drain
–
less than 3m
hose is elevated in the middle
For extending the drain hose, the type of end of drain hose to be used is not "
ㄱ
" type, but "
-
" type.
