7
;
;
;
DRAIN HOSE SETTING
Before operating your washer, install drain hose properly.
First, connect the drain hose to the drain outlet at the
rear side of your washer, and then fasten it tightly with
the hose clamp.
Next, the other end of drain hose set as the below.
!
In case that it goes over a
door sill. Don’t let the height
of the drain hose exceed
20cm from the ground.
@
In case of extending the
drain hose. Don’t let the
total length exceed 3m.
#
Be careful that the end of
the drain hose is not
immersed in water.
20Cm
3m
Pump Model
Non-Pump Model
NOTES
1. Let the highest point of the drain hose be more than 1m above the floor.
If not so, the water in the washer could be drained during operation.
2. Be sure that the height of the drain hose must be less than 1.4m above the floor. If not so, the wart in the washer could not drain.
3. The hose guide MUST be fitted to the drain hose. The drain hose should not extend more than 55mm from the end of the hose
guide. This is to prevent ‘SYPHONING’. If necessary the drain hose can be trimmed to length.
#
Hook the drain hose to the edge of
the tub, paying attention that there
are no bends or constractions
along the drain hose.
Or, connect the drain hose to a standpie
of a diameter greater than that of the drain
hose and at a height of min. 70cm.
$
Attach the hose guide included in the
accessory kit, to guide the drain hose
over the tub or standpipe.
!
Connect the drain hose to the drain outlet
at the rear side of the washing machine,
and fasten it tightly with the clamp
supplied.
@
Attach the hose guide included in the
accessory kit, to guide the drain hose over
the tub or standpipe.
PULL HOSE
THROUGH
55mm
FLEX HOSE
GUIDE
APART
70Cm min
MUST be
ventilated
