15
STEP 9. Additional Instructions for Installation of Your Dryer in a Manufactured or Mobile Home.
The following instructions are applicable to installations of the dryer in a manufactured or mobile home.
Any installation in a manufactured or mobile home must comply with the Manufactured Home Construction and
Safety Standards Title 24 CFR, Part 32-80 or Standard CAN/CSA0Z240 MH and local codes and ordinances.
If you are uncertain whether your proposed installation will comply with these standards, please contact a service
and installation professional for assistance. (CONTACT INFORMATION : 1-877-393-7823(1-877-DWESVC3)
The following instructions apply to any installation of the dryer in a manufactured or mobile home:
1) The electrical connection for an electric dryer must be a 4-wire connection. More detailed information concerning
the electrical connection is provided at the manual section entitled Electrical Requirements for Electric Dryer
2) To reduce the risk of combustion and fire, the dryer must be vented to the outside.
3) Electric dryers may be vented to the outside using the back, left, right, or bottom panel.
4) Gas dryers may be vented to the outside using the back, left, or bottom panel. Gas dryers must not be vented to
the outside using the right side panel because of the burner housing.
5) The dryer exhaust duct must be affixed securely to the manufactured or mobile home structure, the exhaust duct
must be made of a material that will resist fire and combustion, and it is recommended that you use a rigid or
flexible metal pipe.
6) DO NOT connect the exhaust duct with any other exhaust duct, vent, or chimney.
7) Make sure the dryer has adequate access to outside fresh air to ensure proper operation.
The opening for outside fresh air must be at least 25 in
2
(163 cm
2
).
8) It is important that the clearance of the duct from any combustible construction be at least 2 inches (5 cm), and,
when venting the dryer to the outdoors, the dryer can be installed with a clearance of 1 inch at the sides and back
of the dryer.
9) Please be aware that venting materials are not supplied with the dryer.
You should obtain the venting materials necessary for proper installation.
WARNING!
DO NOT connect exhaust ducts with metal screws or fasteners that extend into the duct.
DO NOT vent the exhaust duct under the manufactured or mobile home.
STEP 8. Procedure for Reversing the Door
The door on your dryer can be installed to open either to the left or the right. Follow these instructions to reverse the
direction in which your door opens:
Note : Door and latch should be aligned at the center when closed.
