4
Optical Interlinked Smoke Alarm
Model No. ELA1380
User Manual
IMPORTANT
–
RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
Installing the Battery
Insert a CR123A battery into the
compartment on the underside of the
alarm being careful to observe the
polarity markings inside. Once inserted
the alarm will beep once to confirm it has
powered up.
Always press the Test Button after fitting
a replacement battery to check the alarm
is working.
NB
the alarm cannot be attached to the mounting bracket without a battery fitted.
Mounting Your Smoke Alarm
Once a suitable position has been identified, mark the
fixing holes using the mounting plate as a guide.
Drill two holes with a 4mm Masonry drill bit (not
supplied).
NB
The distance between the two holes is 42mm.
Insert the plastic plugs into the holes.
Pass the screws through the mounting plate into the
plugs and tighten with a suitable screwdriver (not
supplied).
Alternatively, fasten the mounting plate in place using
the double-sided sticky pad provided.
Place the alarm against the mounting bracket and twist
it clockwise to lock the alarm in place as shown right:
To remove the alarm, twist anticlockwise.
Once the smoke alarm is mounted in place, press the
test button in the centre of the alarm to test it for
functionality. The alarm will give three beeps to
confirm it is working correctly.
IF THE ALARM DOES NOT SOUND INVESTIGATE THE
CAUSE IMMEDIATELY.
