3
If the front of the appliance is slightly higher than the rear,
the door can be opened and closed more easily.
LEVELING
To Prepare your appliance for use and check that it is
running correctly, take the following steps.
1. Install removed all shelves and compartments during
transport in the correct positions.
2. Clean the appliance and accessories to remove any dust
that accumulated during packing and shipping.
3. The interior light should be turned on when the appliance
door’s opened
4. Set the temperature control to the coldest temperature
and let the refrigerator operate for one hour.
The appliance should get slightly chilled and the motor
should run smoothly with a soft hum and no noise.
Your appliance is operated by a compressor which
switches “on and off” to maintain the internal temperature.
When compressor is new, it requires running in for a
period of up to five months.
During this period, it may be slightly noisy.
This is quite normal and does not represent a fault.
5. Store food once the temperature in the appliance is
sufficiently low. It takes a few hours after starting the
appliance to reach the proper temperature.
If the appliance does not operate correctly, check the
electricity supply.
If the problem persists, contact your dealer.
Preparing The Appliance
1. The appliance tilts down to the
left.
Turn the left adjusting leg in the
direction of the arrow until the
appliance is lever.
2. The appliance tilts down to the
right.
Turn the right adjusting leg in the
direction of the arrow until the
appliance is lever.
Use of an earthed socket exclusively
For the appliance :
• If you are using a socket with an earthed terminal, you do
not require a separate earthed connection.
Use of a non-earthed socket :
• Connect the “earthed wire” to the steel plate and bury it at
depth of at least 25cm in the ground.
Caution
