METHODS OF SAFE INSTALLATION
1. SAFE INSTA L L ATION PLACE FOR YOUR REFRIGERATO R
4
•
Place the refrigerator on
hard and level floor.
•
Place your refrigerator
where there is no heat
source nearby.
High surrounding
temperature will lower
cooling efficiency and
increases your electricity
b i l l .
•
Place the refrigerator in
an area with low
m o i s t u r e .
Splashing water or a
high moisture area may
cause a short circuit and
make rusting easier.
•
Avoid places that are
exposed to smoke.
The discoloring can
occur to the refrigerator.
•
For good ventilation
place refrigerator with
the spaced specified on
the figure.
This helps cooling
efficiency and lowers the
electricity bill.
•
Placing the refrigerator
on the carpet may cause
heat to develop and
discolor the appliance. In
such a case put a hard
wooden board or a
rubber mat between the
refrigerator and the
c a r p e t .
HOW TO OPERATE
1. TEMPERATURE CONTRO L
3
Temperature is controlled by thermostat automatically.
The Temperature Control inside the refrigerator controls the degree of
cooling for each compart m e n t .
F r e e zer Temperature Contro l
The control has four settings fo rm
MIN to WINTER. The WINTER
mode is ava i l a ble only if atmosphere
t e m p e rature is below 10°C.
R e f r i gerator Temperature Contro l
The control has the four settings from
MIN to WINTER. The WINTER mode
is ava i l a ble only if atmosphere
t e m p e rature is below 10°C.
Starting your new refrigerator
To control temperature
M a ny factors may influence the internal temperature of the refrige r a t o r
and freezer compart m e n t s .
■
The temperature and humidity of the surrounding env i r o n m e n t .
■
The opening frequency of the doors and the amount of wa rm food placed in
the refri g e ra t o r.
■
The combination of food and containers stored in the refri g e ra t o r.
For these reasons, you may want to adjust the control to suit the season and your needs.
1. Clean the refri g e rator thoroughly. Wipe the outside with a dry cloth, and the inside
with a damp cloth.
2. Set the temperature control knob at normal position.
3. Connect the power supply cord.
