FUNCTIONS
A. “TEMP” Button
1. Temperature control of Refrigerator compartment
2. 5 step mode of successive temperature mode
3. Initial mode by power input: step “3”
4. Temperature will be set if the button doesn’t get pressed again within 5 sec.
- Whenever pressing “TEMP” button, setting is repeated in the order of
“3”
→
“4”
→
“5”
→
“1”
→
“2” (LED LAMP ON)
B. Temperature of Refrigerator Control
1. COMP and FAN will be controlled by the on/off condition of each mode.1
2. Temperature Difference of Refrigerator each step :
3. Temperature of Refrigerator
at step “3” OFF point: is -1.4C
4. Refrigerator ON/OFF Temp.
Difference: 1.7C
C. “S-COOL” MODE
1. Press S-COOL SWITCH
and make S-COOL led lamp on.
2. COMP & FAN are on
until R-sensor
reaches to “Over Refrigeration
OFF Point”, -7C
3. After the reach of -7°C , STEP “5” mode continues.
4. When “S-COOL” MODE (Quick Refrigeration Mode)
lasts for about 40 minutes, it returns to general
operation mode.
D. Temperature of Freezer Control
-It will be only controlled by using
“KNOB F LOUVER”
in Freezer.
PCB Control Panel LED
COMPRESSOR, FAN
CONTROL OBJECT
INPUT
PCB Control Panel “TEMP” Buttons
R-sensor
2. Temperature Control of Refrigerator Compartment
Step '1' '2' '3' '4' '5'
ON
OF
Temp
Dial
4.3 C
2.3 C
0.3 C
-1.7 C
-3.7 C
2.6 C
0.6 C
-1.4 C
-3.4 C
-5.4 C
“5”
“4”
“3”
“2”
“1”
Temperature Step
2.0C
2.0C
2.0C
2.0C
Temp. Diff. of Each Step
10
