26
(1) Remove the gasket door(A07) from door painting ass’y(A05).
(2) Remove the door frame(A01) from door painting ass’y(A05).
(3) Remove the barrier screen outer(A02) and the supporter barrier screen outer(A03).
(4) Remove the hook spring(A09) and the hook(A08).
(5) Remove the hinge stopper top ass’y(A04).
(6) Remove two screws(A11) which secure the handle door(A10).
(7) Rmove the handle door(A10) from the door frame(A01).
(8) Reverse the above steps for reassembly.
4. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part ‘A’.
1) Loosen two screws on the top hige
stopper,and then push the door to con-tact
the door seal to oven front surface.
2) Tighten two screws.
(2) To reduce gap located on part ‘B’.
1) Loosen three screws on bottem hinge stopper,
and then the door to contact the door seal to oven front surface.
2) Tighten three screws.
(3) To reduce gap located on part ‘C’. (See Fig. A)
1) Loosen a screw on the interlock switch assembly located at the bottom of the oven body.
2) Draw the interlock switch assembly inward as possible to engage with hook on the door bottom.
3) Tighten a screw.
(4) To reduce gap located on part ‘D’.(See Fig. B)
1) Loosen a screw on the interlock switch assembly located at the top of the oven body.
2) Follow step (3) 2) and 3).
Secondary
interlock
switch
Mounting screw
Hook
Mounting
screw
Hook
Primary
interlock
switch
Interlock
monitor
swtich
NOTE
:
A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm
2
.
Fig. A
Fig. B
A
B
C
D
Stop
Defrost
1
2
Weight
Quantity
Time
Lock
Auto cook
Watt
g
Power
Defrost
+1min
Auto Cook
STOP
START
CLEAR
Speedy
More
Less
Clock
Tim
er
/W
ei
gh
t/Q
ua
nt
ity
1. Beveroge
2. Soup
3. Casserole
4. Vegetable
5. Fish Fillets
Summary of Contents for KOR-616T0P
