•
Apply oil to the entire part of the bearing
cap bolts, then tighten in tightening
sequence to specified torque.
•
After semi-tightening both bolts evenly,
tighten them diagonally to about 15kg.m
for the first stage and 25 kg.m for the
second stage respectively, then tighten
them completely to the specified torque
using a torque wrench.
•
Tighten the bearing cap in the sequence
of 4-3-5-2-6-1-7.
•
Check to see that the assembled crank-
shaft turns smoothly.
3.3.6. Flywheel housing
•
Temporarily install the guide bar on the
cylinder block.
•
Apply gasket to the cylinder block.
•
Using the dowel pin and guide bar,
install the flywheel housing and tighten
the fixing bolts in a diagonal sequence
to specified torque.
3.3.7. Rear oil seal
•
Apply lubricating oil to the outside of
theoil seal and flywheel housing inside
diameter and fit them over the crank
shaft, then assemble the oil seal using
an oil seal fitting jig.
- 61 -
EQM3059I
EQM3060I
Torque
30 kg
•
m
Torque
12 kg
•
m
