Installation preparation
The picture below is for demonstration purposes only. The model shown may differ from the one purchased
✽
Check if the refrigerator can pass a doorway or
enter a door first.
Dimension ( including door handles)
(Width*Depth*Height) 906mm×735mm×1770mm
✽
Find a suitable place to install
Sufficient space from the back of refrigerator to the wall
for free air ventilation.
✽
Keep away from heat and Avoid direct sunlight.
1. Ventilation
Do not block air vents. If they are blocked during operation, the
product may overheat and eventually cause a failure. For
proper ventilation, allow above 20cm of space between fridge
freezer sides, rear and the minimum height of free space
necessary above the top surface of the freezer is 30cm.
2. Steady, flat location
This appliance should be set on a steady, flat surface. This
fridge freezer is designed for domestic use only.
3. Leave space behind and side
All air vents should be kept a clearance. If all vents are covered
during operation, the appliance may overheat and, eventually,
failure.
4. Away from heating appliance and water taps
Keep the product away from hot air, steam or Splash when
choosing a place to position it, or the insulation might be
adversely affected and breakdowns occur.
The appliance should be installed well away from sources of
heat such as radiators, boilers, direct sunlight etc. Ensure that
air can circulate freely around the back of the cabinet. To
ensure best performance if the appliance is positioned below
an overhanging wall unit the minimum distance between the
top of the cabinet and the wall unit must be at least 20 cm
ideally. However the appliance should not be positioned below
overhanging wall units. Accurate levelling is ensured by one or
more adjustable feet at the base of the cabinet.
5. Power supply
• Check your local power source. This appliance requires a
current of approximately 220-240V 50Hz.
• Power supply cord is about 1.6 meters long.
• The voltage used must be the same as specified on this
appliance. Using a higher voltage may result in a fire or other
accident causing the damage. Using low voltage will cause
failure of operation. We are not responsible for damage
resulting from use of this appliance with a voltage of ampere
fuse other than those specified.
• If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person
in order to avoid a hazard.
Once the installation place is ready follow
the installation instructions.
If the surrounding temperature of
refrigerator is low (below 5⁰c), foods can
be frozen or the refrigerator can function abnormally.
