Daewoo RFS-26B Series, User Manual

16

Foldaway door bar (mullion bar)

- When closing the left refrigerator door, the mullion bar 
  folds behind the right refrigerator door, foaming a seal 
  between the refrigerator doors.
- When opening the left refrigerator door,  the mullion bar 
  folds back to the left door automatically.

(mullion bar folds back O)        (mullion bar folds away X)

- The mullion bar become damaged if you attempt to close  
  the left refrigerator door with mullion bar fold away 
  When closing the left refrigerator door, make sure the 
  mullion bar is folded back.   

Water filter 

1. Disconnect the water supply to the 

    appliance.

2. Remove the locking cap for  

installing the filter.

(The ice and water dispenser can  
    also be used without a water filter, 

    in which case the locking cap must 
    be used. ) 

 
 3. Carefully turn the filter clockwise.
 4. Change the filter at least every
     6months.

  A New filter can be obtained from aftersales service.
  

Caution

●

Wipe up with cloth if droplets fall when       

 exchanging 

a 

filter. Draw water from the water 

dispenser for 5 minutes before use. This will 
remove air from the water system.

Information concerning the water filter

- After use, the water system is subject to low pressure.
  Proceed with caution when removing the filter.

- Flush the water system if the appliance has not been in   
  use for a lengthy period, or if the ice/water has an   
  unpleasant taste or smell. To do this, dispense water  
   through the water dispenser for several minutes.
  If the unpleasant taste or smell remains, replace the filter.

- Protect from frost, remove the filter cartridge if you expect  
   the temperature to drop below freezing.

- If pressure surges could occur in the water pipe. Do not  
  install the water filter without a suitable surge eliminator.   
  Contact an installation expert if you are not sure whether  
  pressure surges could occur in the water pipe.

- After installing a new filter:
   Discard any ice produced in the first 24 hours after  
  switching on.

- If no ice has been removed for a lengthy period: Empty the  
  ice box and discard any ice produced over the next   
 24hours.

How to install Water Line

1. The water pressure should be 2.0 ~ 8.8kgf/

㎠

    (1.96~8.62 Bar)or more to run the automatic icemaker.
 

Checkup your tap water pressure ; if a cup of 180cc is   

full within 10 seconds, the pressure is OK.

2. When installing the water tubes, ensure they are not    
 

close to any hot surfaces.

3. The water filter only filters water ; it does not eliminate   
 

any bacteria or microbes.

4. If the water pressure is not so high to run the icemaker,  
 

call the local plumber to get an additional water pressure  

 pump.
5. If the water pressure exceeds 8.8kgf/

㎠

(8.62Bar) a 

     pressure reducing valve must be installed.

6. The filter life depends on the amount of use. We  

recommend you replace the filter at least once every    

 6 

months.

7. After installation of refrigerator and water line system,    
 

select [WATER] on your control panel and press it for   

2~3 minutes to supply water into the water tank and    

 dispense 

water.

8. Use sealing tape to every connection of pipes/tubes to   
 

ensure there is no water leak.

9. The water tube should be connected to the cold water   
 line.