11
IDENTIFICATION (continued)
#
DC JACK IN (12V DC), OPTION1
Connect this jack to DC source (DC 12 volts, PLUS and GND). For car using, please use connection via connector 4 (OPTION 2) for
proper working.
$
DC JACK IN (12V DC), OPTION2
For car using, we recommend to use this connector with 3-wire system.
* Connector description for
$
* Please note : We highly recommend to connect the unit corresponding to the 3-wire system of OPTION2. Thus, to make sure a
proper working of power-off tape guide. Beyond it, the unit will automatically change to standby mode after turning
off the vehicle in order to save the car battery.
%
IR INPUT
Connect this terminal to remote control out.
NOTE:
This VCP is for 12V use only, so do not use it in 24V vehicles.
If you use this set in a 24V vehicle, all the indicator lamps will blink. To avoid the malfunction of this set, please disconnect the plug from
the power source.
DV-SC242WY-RV_GB 01.2.22 2:53 PM ˘
`
11