Daewoo SD-8500P, Owner'S Manual

18

Initial Installation

Setting up the player

■

Switch the TV on.

■

You can also start "AUTO SET" in the SETUP "PR PRESET" 

"AUTO SET".

■

To tune in new stations (manual tuning) and enter station names see page 25-26. 

SETUP:END

PLEASE WAIT...

CH 25

RF OUTPUT SET

0-9:SELECT(21-69)
OK:CONFIRM      SETUP:END

CURRENT

CH 52

RECOMMENDED CH 

54

You should see this picture the first time you switch on the TV
and player.

1

OK for "AUTO SET!".
"AUTO SET" tunes in all the stations you can receive in your
country and sorts them in an order common for your country.
Clock is automatically set.

2

If other stations are positioned on near the current RF OUTPUT
CH, the guide message appears automatically.

The player recommends the optimal RF OUTPUT CH number
automatically.

3

Press the [OK] button to confirm the recommended PR.

Should you wish the stations to have the same numbers as those
used on the TV, follow the instructions in "Sorting programme
locations" on page 26. 

Otherwise ...
exit the basic installation function and enjoy your player.

4

PLEASE CHANGE THE TV 
CH TO 54.

IMPORTANT!

MANUAL SET

PR01 BBC1 PR08 SKYS
PR02 BBC2 PR09 MTVE
PR03 ITV

PR10 P-10

PR04 CHA4 PR11 P-11
PR05 SKY1 PR12 ----
PR06 SKYN PR13 ----
PR07 SKYM PR14 ----

PR+/-:SELECT
OK:CONFIRM      SETUP:END

• If you don´t see this picture, because you don´t use a SCART cable,

search this picture now (CH 52) with the station tuning functions of
your TV set (see its user manual).

•

In case of interference problems on CH 52, type in an 
other transmission channel between 21 and 69 using 
the number buttons. 
But use the optimum CH number first!

OK:CONFIRM        SETUP:END

AUTO SET

Basic

O

peration

19

■

Press [VCR] button on the remote control to change into VCR Mode and follow the procedure
below. 

Call the player’s "SETUP", 
choose "VCR SETUP", then "CLOCK SET".

1

Move to the position you want to change and type in the
new values.
Wait a few seconds after typing a one-digit number.

2

Store with [OK] button and exit with [SETUP] button.

CLOCK SET

0-9:SETUP (HOUR)
</>:CORRECT       SETUP:END

TIME  - - : - - 

DATE  - - / - - /- - - - 

CLOCK SET

0-9:SETUP (HOUR)

</>:CORRECT
OK:CONFIRM       SETUP:END

TIME  06:05

DATE  08/06/2003(SUN)

Setting time and date

Setting time and date / Auto clock

■

Auto Clock is only available for models with the VPS/PDC function (see page 27).

Some broadcasting stations may send the time and date along with the VPS/PDC data. The video will
automatically use this time and date during the initial setting up procedure during normal use, and
every time you switch the video off at the mains. If you find that this time and date is incorrect you can
remove this feature by following the steps below changing it to the OFF mode, you will then have to
manually set the time and date, see above.

AUTO CLOCK

ON
OFF

PR+/-:SELECT
OK:CONFIRM       SETUP:END

Setting Auto clock

VCR SETUP

CLOCK SET
RF OUTPUT SET
16:9 SET
OSD ON/OFF
AUTO CLOCK

PR+/-:SELECT
OK:CONFIRM         SETUP:END