Installation
• IMPORTANT!
This appliance must be left to stand in an upright
position for a minimum of 4 hours prior to switching on for the first
time.
• Please read these operating instructions thoroughly and keep them in
a safe place for future reference.
• Remove all packing materials and discard responsibly.
• Clean the interior of the appliance with lukewarm water containing a
small amount of bicarbonate of soda (5ml to 0.5 l of water)
• Position the appliance out of direct sunshine.
• Do not position next to a cooker or other sources of heat such as a
radiator.
• If positioned next to another fridge or freezer, leave a minimum gap of
2cm between the appliances to avoid condensation.
• A clearance of 50mm should be left above the appliance, if this is
not possible 25mm of clearance should be left on each side of the
appliance.
• Ensure there is a clearance between the condenser and rear wall.
• Do not place heavy items on top of the appliance.
•
Position the appliance on a solid flat surface.
• This appliance must be level. Adjust the level by screwing the
adjustable feet up or down as required, using your fingers or a
suitable spanner.
• Ensure that the power supply is in accordance with the rating plate
found at the rear of the appliance.
• Do not push objects into any openings as damage to the appliance
and/or electric shock may occur.
• Do not use any accessories or attachments with this appliance other
than those supplied or recommended by supplier.
Operation
You may hear faint gurgling or bubbling sounds as the refrigerant is
pumped around the cooling circuit, this, along with the slight hum of the
compressor is normal and will stop and start as the thermostat operates.
Drinks Chiller
SDA2252
User Manual
