4. Additional data for operation
VMCTOPES8D51
4. Additional data for operation
In this chapter, the general items applicable to the other machining centers are explained, and
please read carefully and refer to that at any time - during programming and operation.
<Contents>
Item
Description
Remark
Page
4.1
Conditions for each operation
– State to be prepared for each operation
4 – 1
4.2
Main operation and MDI command
– ATC and APC motion vs. MDI command
4 – 2
4.3
Use of large tool
– Loading large tool and proramming
4 – 7
4.4
Use of singel point boring tool
– Change of cutting edge position with
each machine
4 – 7
4.5
Program code & cycles
– Brief information about typical program code
and cycle
4 – 8
Additional data for operation
4 – 0
