DRPB48 Operation Manual
4) Disassemble
clamping sleeve (#3)
:
5) Take out the
3-jaw set (#4)
from the
clamping sleeve (#3)
, then remove the
assembly pusher
(#5)
and the
pusher spring (#6)
from the tool. Once removed, inspect all parts for wear
before cleaning and replacing them. Any damaged parts should be replaced at this time.
6) Re-assemble the cleaned or replacement parts. Put the
pusher spring (#6)
onto the
assembly pusher (#5)
and insert it back to the tool where
assembly oil cylinder (#11)
is
located;
7) Place the
3-jaw set (#4)
into the
clamping sleeve (#3)
and be sure that all 3 jaws are seated
in the correct position;
Summary of Contents for DRPB48
Page 8: ...DRPB48 Operation Manual ...
