DRPB64V Operation Manual
TOOL CAPACITY
Blind rivets 4.0mm – 4.8/5.0mm – 6.4mm standard; 6.0mm optional.
TOOL SPECIFICATIONS
Air supply pressure:
0.5Mpa ~ 0.7Mpa
Output traction power:
12,300N ~ 17,220N
Stroke:
20mm
Net weight:
1.70kgs
GETTING STARTED
Please refer to the
TOOL EXPLOSIVE ILLUSTRATION
and the
PARTS LIST
in this manual in
order to have a good understanding of the tool parts described. The descriptions of the tool parts
appear in this manual are in
italics
with the parts position
numbers
corresponding to the tool
explosive illustration.
1) This pneumatic powered tool should be used with a compressed air supply. It is
recommended to use an air hose with a diameter bigger than 8mm.
2) Before connecting the tool to the compressed air supply, check that the compressed air
pressure is within the specified range of between 0.5Mpa ~ 0.7Mpa. Once the air pressure
has been confirmed, connect the air hose adaptor onto the tool
air adaptor (#52)
. The air
adaptor comes in different versions in different countries. Normally the tools are equipped
with the correct version for your country as default, however, if the air adaptor you have
received does is incorrect, please contact the tool distributor(s).
3) Change and use the correct
nosepiece (#1)
according to the size of the rivet to be set. This
tool is equipped with nosepieces from 4.0mm, 4.8mm, and 6.4mm (on the tool) in the tool
kit. Follow the steps below to change the
nosepiece (#1)
:
a) Remove the air supply hose from air adaptor (#52).
b) Use the
wrench (in accessories pack)
to remove the
nosepiece (#1)
from the tool as
below;
c) Select the correct
nosepiece
from the accessories pack and screw on to the tool, using
the
wrench
to fix it firmly on the tool.
4) Install the
mandrel collector (#24 in accessories pack)
on the back of the tool.
