DRPB64V Operation Manual
TOOL OPERATION FOR SETTING BLIND RIVETS
1) After completing the start-up preparations, place the rivet mandrel into the nosepiece, and
holding the tool securely, insert the rivet into the pre-drilled hole of the work piece that needs
to be fastened.
2) Pull the tool
trigger (#48)
to set the blind rivet in its position in the work piece.
3) After setting the rivet, the used mandrel will be sucked into the
mandrel collector
(#24)
at the
back of the tool automatically. Always have the
mandrel collector
on the tool when in use, in
case a rivet mandrel comes shooting out from the back and causes injuries. Be sure to
empty the
mandrel collector (#24)
when half full otherwise the tool will not be able to release
used mandrels properly which can cause serious damage to the tool.
4) The power of the vacuum can be adjusted to stronger or weaker by turning the knob on back
of the tool which is visible when the
mandrel collector (#24)
is removed.
5) On the
air adaptor hose (#53)
equipped for this tool, there is a sliding switch to pause/switch
off the air supply to the tool when not in use.
TOOL MAINTAINANCE
In order to maintain optimum performance after several weeks of regular use, add a few drops
of hydraulic oil on the inlet of the
air adaptor (#52)
of the tool in order to reduce the friction of
the tool parts, as the oil will be blown inside the tool when it is in operation.
The tool stroke may be reduced after a period of use, which indicates that the hydraulic oil in
the pneumatic tool needs to be refilled or changed;
1) Remove the
screw (#11)
with a hexagon wrench:
