Note!
Push and CLICK the solar panel in the holder
Step 8: Assembling the solar panel holder
Step 9: Installing the solar panel
Assemble the solar panel holder as shown on the drawing,
using the 2 pcs M3 x 8 screws and 2 pcs M3 nuts.
Install the solar panel as shown on the drawing.
Solar panel holder
Screw M3 x 8
2 pcs.
Lock nut M3
2 pcs
Solar panel
CLICK
CLICK
Step 10: Installing the battery clips
Battery clip
4 pcs.
Install the 4 battery clips as shown on the drawing.
The completed solar car !!!
Step 11: Solar panel operation
Assemble the wires
as shown on the
drawing.
Electronic circuit diagram
Solar panel
Motor
Switch
The solar panel operation will only succeed in very bright SUN or LAMP light!
1.5 Volt
FIRST PUT A PIECE OF ABOUT 1 CM TUBE AROUND THE WIRE!
a. Push the unisolated wire through the hole of the solar panel connectors and
wrap it around 2 or 3 times (see small detail drawing).
b. Connect the 25 cm blue wire from the switch to the + of the solar panel.
c. Connect the blue motor wire to the - of the solar panel.
d. Push the tube over the solar panel connectors so the tube will fix the wire
properly.
Now you can put
the stickers on your
Solar Car.
See the packaging
for design ideas
.
The rotation direction of the motor
(driving forwards or backwards)
depends on the + and - connection of
the battery or solarpanel. Change the
polarity (+ and -) to change direction!
English
