Chapter 10 Other Functions
4.
If the factory password had been already set (but hadn’t been decoded), and the
embroidery factory administrator password had already been set (but hadn’t been
decoded), the initialization would turn the machine parameter managed by factory to
value saved by factory, the machine application password managed by the administrator
to the values saved, and the other parameters would be turned to default value saved by
system.
5.
If the factory password had not been set and the embroidery factory administrator
password had already been set and decoded, the initialization would turn the entire
general embroidery parameter to the default value saved by system.
6.
If the factory password had not been set and the embroidery factory administrator
password had already been set (but hadn’t been decoded), the initialization would turn
the machine application password managed by the administrator to the values saved by
the administrator, and the other parameters would be turned to default value saved by
system.
10.8 Machine Information
Operation Procedures:
1.
At main interface, press "
" to enter the machine parameter management
interface.
2.
Click “Machine Info”
This function will help users to check u machine software information. Click
to exit.
10.9 Debugging Machine
This operation is only for the repairman, the ordinary operators are banned to use
Owner’s Manual of BECS- 285A Computerized Control System
107
