Chapter 11 About JF Sequin Embroidery
5.
Sequin-feeding method and the feeding angle can be changed via the
operation panel.
Ⅲ
. Specifications
1.
Size of Sequin available: Diameters at 3mm, 4mm, 5mm, 6.75mm and 9mm
；
2.
Max speed at 850rpm.
11.2 Embroidery Procedure of Sequin
At sequin embroidery, user needs to follow the procedure at below:
1
．
Input design with sequin code, refer to 11.3
2. If necessary, please transform and edit the design, please refer to 11.4);
3. Set the sequin parameter according to the setting instructions in 11.5.
4. Check and adjust the sequin-feeding device (Refer to 11.8), so as to make sure the
sequin-feeding device works normally;
5. Set color-changing order (Refer to
6. Return to main interface and confirm the embroidery;
7. Start embroidery.
Attention: during the embroidery, don’t dial the manual switch for moving the valve, or it
will cause the damage of the sequin-feeding device.
11.3 Input Sequin Design
Press
in the design management to enter disk selection interface to open the disk
needed. After selecting design for input, user needs press
to have access to the design
input interface as shown in below:
Owner’s Manual of BECS- 285A Computerized Control System
111
