Chapter 12 Operation of Zigzag Embroidery
Chapter 12
Operation of Zigzag Embroidery
12.1 Functions
1.
Zigzag Embroidery (ZIG Embroidery): this function is to make the thread form the
design with certain stitch forms, which have been saved in the computer in advance,
the Z4 and Z5. The figures of these two kind of ZIG embroidery are shown at below:
Z4 Embroidery Z5 Embroidery
2.
User can set the max speed for flat embroidery and the top speed for zigzag
embroidery respectively.
3.
Auto saving of the stop point of the M axis
：
M axis will return to the stop point when
the power resumes.
4.
Thread-trimming for Zigzag Function (Trim bottom thread Only)
5.
Before manual frame-moving, the zigzag device can lift the presser automatically,
while it can also lower the presser before the embroidery.
12.2 Key Technical Indexes
1
、
Speed of Zigzag: 300~1000rpm, unit: 10rpm.
2
、
M Axis Manual/ Auto Rotation Step: 18
°
/Step.
12.3 Procedure of Zigzag Embroidery
(1) Input zigzag embroidery design, then select, adjust and edit the design according to
needs;
(2) Change parameter, select color-changing order and decide embroidery mode;
(3) Check zigzag embroidery position, and make sure it works normally;
(4) Start Embroidery
12.4 Related Parameter and Setting Mode
Click parameter setting key
in main interface, then user can set the parameters
relating to the zigzag embroidery
.
1.
Right Zigzag Device: Y (N) —— Y means the first needle is the zigzag embroidery
position.
2.
Left Zigzag Device: Y (N) —— Y means the last needle is the zigzag embroidery
position.
124 Owner’s Manual of BECS- 285A Computerized Control System
