Chapter 12 Operation of Zigzag Embroidery
12.5.2.
M Axis Operation of Zigzag Embroidery
The operations about M axis contain “M axis to be ready”, “M axis to cycle” and “M
axis to turn”, which are all in the Assistant Functions. In the main interface, you can click
to enter into the “Assistant Operation” interface. Turn the page, then you can see the
parameters “M axis to be ready”, “M axis to cycle” and “M axis to turn” displayed in order..
（
1
）
Return M Axis to Working Point
Press the key “M axis to be ready” and click
on the dialogue window to let
the M axis back to the working point, click
to exit.
（
2
）
Return the M-axis to the Origin Point (Step Moving)
Press the key “M axis to cycle” and click
on the dialogue window to let the
M axis rotate to the “Zero point”, click
to exit the operation.
（
3
）
Rotate M Axis Manually
Press the key “M axis to return” and click “turn to left” on the dialogue window to let the
M axis rotate to the left. It will rotate 18° left once you click the button. After 20 times click, it
will return to its origin; while click “turn to right” on
the dialogue window to let the M axis
rotate to the right. It will rotate 18° right once you click the button as well. After 20 times click,
it will return to its origin; click
to exit.
128 Owner’s Manual of BECS- 285A Computerized Control System
